Aktív témák
-
RAM
őstag
Hi!
1 kis help kellene!
C: FAT32
PQ8 DOS
Nem ment a Resize, kiválasztottam a méretet: 4,330,5 MB
És nem tudta elvégezni, 2x írt ki hibát, vmi FAT-ra hivatkozott (#2003); Too much bad -> vmi bad.
Nem végezte el a méretezést,
ha elvégezte volna, akkor hogyan tovább?
Marad 15 GB, kijelöl üres helyet, primary to logical?
(ide csinálnék 3 különböző méretű partíciót.Csak tisztán
-
RAM
őstag
Diskeeper
Windows XP
Kérdésem, DERFAG közben lehet mást csinálni?
- NET, zene,
Nagyon lassú:
Konfig: 1700+; 512 MB; 20 GB 82 % szabad
''Directory fragmentation
Total directories = 2,669
Fragmented directories = 37
Excess directory fragments = 169
''
KB. meddig fog tartani?
Ha nyomok 1 pauset, és ste újra lindítom, folytatni tudja, onnan, amennyit már +csinált, v újra előlről kedi?
Fontos!
THX!Csak tisztán
-
RAM
őstag
Findings on C:
Diskeeper has completed a defragmentation run on this volume and there remain 37 fragmented files and/or directories and 169 excess fragments. (There were 6831 excess fragments before the defragmentation run, and now there are 97% less.)
The average number of fragments per file is 1.00.
On average, you have 0% excess fragments per file on this volume. This is a slightly fragmented volume. You should schedule Diskeeper to run at least once a day (if you haven't already done so) to keep fragmentation at a low level.
Nincs FDD-m, CD-íróm,
PQ8 (DOS)-om van.Csak tisztán
-
RAM
őstag
[L]http://www.powerquest.com/support/primus/id4184.cfm[/L]
akkor ezek alapján addig +vagyok, h RESIZE, van egy 4GB és 15 GB free (Unlocated)
első sor 4 GB
2.sor Unlocated 15 GB
Mire kattintok?
Hogy 3 db másik partíciót létre tudjak hozni?
RESIZE / MOVE / COPY / PRIMARY TO LOGICAL
Ezek vannak.
FAT32 mind.
nem csak 1 Bootolhatót szeretnék. (PRIMARY?)Csak tisztán
-
#38
RAM
őstag
h4ndsp1k3n
#37
RAM
őstag
válasz
h4ndsp1k3n
#37
üzenetére
Mint már írtam lefuttattam a DISKEEPERT. :)
És még lefogom 3x, mielőtt belekezdek.
IDÉZET A PROGRAMBÓL:
2. GENERAL USAGE NOTES
----------------------
- PartitionMagic does not support Windows NT Server or
Windows 2000 Servers.
- Be aware that there is no undo (after clicking Apply) if you
merge two FAT or FAT32 partitions. You must be particularly
careful not to merge two primary partitions that include
operating systems, as your computer will not be bootable if
you do.
- Progress bars are an estimation only and may pause for several
minutes, even though PartitionMagic is still working correctly.
If you think your computer has locked up, please be patient and
allow PartitionMagic to finish the operation.
- You should set up removable media drives so that they are the
last drives on your system. Drives are assigned priorities as
follows: primary master, primary slave, secondary master,
secondary slave. You should not have a fixed hard drive
set up as the secondary master if you have a removable media
drive set up as the primary slave. If you have two IDE
controllers, you should connect removable media drives to
the second controller, after any hard drives. If you have a
RAID configuration, disconnect any removable media (such as
a Zip drive) before using PartitionMagic. If you do not
configure removable media drives as the last drives, you
will see disk numbering inconsistencies in the PartitionMagic
interface, and the wizards will not work on your system.
- Bad Sector Checking is OFF by default. PartitionMagic ships
with bad sector checking turned OFF by default. Modern hard
disks are designed to avoid bad sectors automatically.
However, if you feel that bad sectors may be a problem on your
system, turn on bad sector checking (by unchecking the
appropriate boxes in the ''Skip bad sector checks'' list box in
Preferences). Turning on bad sector checking ensures that data
is not moved or copied to bad disk sectors; however, this
causes the create, move, and resize operations to slow down
considerably. Another way to verify that there are no bad
sectors on your disk is to run the operating system check
utility (CheckDisk or ScanDisk) and do a surface scan before
launching PartitionMagic.
- A non-Asian language version of PartitionMagic should never
be used on an Asian language version of Windows NT/2000/XP,
as this may cause corruption of filenames and partition/
volume set labels.
- You cannot use PQBoot for Windows (a utility included with
PartitionMagic) unless there is at least one primary
partition on the first hard disk.
3. KNOWN ISSUES - WINDOWS NT/2000/XP ONLY
-----------------------------------------
- PartitionMagic does not support volume sets, stripe sets, stripe
sets with parity, or partitions located on disk mirror/duplex
sets configured using Windows NT Disk Administrator. Under
Windows 2000/XP, PartitionMagic supports standard partitions
located on basic disk sets only.
- In a configuration with mixed IDE and SCSI hard drives, Windows
NT does not always see the boot drive as the first physical hard
disk. PartitionMagic displays drives in the order Windows NT
reports them. As a result, you may see your boot device as Drive
1, 2, and so forth. This does not cause problems for
PartitionMagic except when setting a new active partition. Also,
PartitionMagic may incorrectly report that there is no active
partition on your system. To change your active partition, be
sure that you identify which drive is the boot drive.
- You should not change the drive letter originally assigned to
the Windows NT/2000/XP boot partition (the partition where Windows
is installed). Changing the drive letter to anything but its
original designation will cause severe boot problems and may
cause your computer to be unbootable.
- Under Windows 2000 or Windows XP, if you perform operations
on partitions that include mount points, you must restore the
mount points after the operations are complete.
- Error 183: Init Failed. If you attempt to run PartitionMagic on
a Windows 2000/XP Professional machine where the boot partition
(the partition where Windows 2000/XP Professional is installed)
is on a dynamic disk, you will receive the following error message:
''Init failed: Error 183. Unable to identify the Windows partition.''
To solve this problem, Windows 2000/XP must be installed on a
basic disk.
- Error 184: If you encounter error 184 when initializing
PartitionMagic, run Disk Administrator (Windows NT) or Disk
Management (Windows 2000/XP), then start PartitionMagic again.
- If the System Restore feature of Windows XP is monitoring a drive,
PartitionMagic cannot perform operations on that drive in Windows.
Instead it must drop down to boot mode to perform the operations.
The operation will still be successful.
- To uninstall PartitionMagic under Windows XP, you must be logged
in as the user who originally installed the product. If the user
account has been deleted, you must remove PartitionMagic
manually by cleaning out the PartitionMagic install directory and
registry.
IDÉZET VÉGE.
Ebből mi a lényeg?
Sajnos gyér angol tudásomban nem bízom, ha vki összetudná foglalni, megköszönném.Csak tisztán
-
RAM
őstag
2. DEFRAG:
Findings on C:
Diskeeper has completed a defragmentation run on this volume and there remain 41 fragmented files and/or directories and 166 excess fragments. (There were 599 excess fragments before the defragmentation run, and now there are 72% less.)
The average number of fragments per file is 1.00.
On average, you have 0% excess fragments per file on this volume. This is a slightly fragmented volume. You should schedule Diskeeper to run at least once a day (if you haven't already done so) to keep fragmentation at a low level.
Az előző 97% volt!!!
Jó?Csak tisztán
Aktív témák
- Hobby elektronika
- Autós topik látogatók beszélgetős, offolós topikja
- Nincs több főgombos iPad, van helyette nagyobb Air és Pro M4 chippel
- Futás, futópályák
- iPad topik
- D1Rect: Nagy "hülyétkapokazapróktól" topik
- Samsung Galaxy Watch (Tizen és Wear OS) ingyenes számlapok, kupon kódok
- Telekom mobilszolgáltatások
- Azonnali informatikai kérdések órája
- Honor Magic5 Pro - kamerák bűvöletében
- További aktív témák...
Állásajánlatok
Cég: Promenade Publishing House Kft.
Város: Budapest
Cég: Ozeki Kft.
Város: Debrecen