- Hálózatokról alaposan
- Xiaomi AX3600 WiFi 6 AIoT Router
- Sokat fogyaszt az AI, egyre több az adatközpont, kell az atomenergia
- Az iPadOS-re írt appokra is díjat vet ki az Apple
- Letartóztatták a bitcoin-Jézust
- ASUS routerek
- Asustor NAS
- Súlyos adatvédelmi botrányba kerülhet a ChatGPT az EU-ban
- A pápa egyre jobban tart a romlott AI veszélyeitől
- Milyen program, ami...?
Új hozzászólás Aktív témák
-
Parson
addikt
no közben találtam erre egy megoldást:
Description
-----------
How to set the hatching spacing and the hatching angle by default in the Xsection.
Alternate Technique
-------------------
See Resolution below.
Resolution
----------
In Release 20.0, the spacing and angle of cross-hatching in newly created planar and offset cross-sections can be controlled.
To control the display, set the number parameters ''default_xhatch_spacing'' and ''default_xhatch_angle'' using the SETUP menu or the RELATIONS menu.
These two parameters are not predefined in Pro/ENGINEER. To create them, select #Setup, #Parameters, #Part, #Create, #Real_number and enter the parameter name and its value :
For example, enter ''default_xhatch_spacing'' and set it to 5; then enter ''default_xhatch_angle'' and set it to 30.
The parameter units is depending to length unit for the spacing and the angle units for the angle.
These parameters only affect new cross-sections.
az egyedüli baj csak ott van ezzel, hogy mig az angle opció perfekt módon müködik, addig a spacing sehogysem akar a beállitott értékre ugrani, és úgy megjelenni metszet készitésénél, sem proe2001 2005030-asban, sem Pro/E wf2 m171-esben, és még Pro/E wf2 m250-esben sem... kicsit bosszantó... van vkinek vmi ötlete ezügyben?───────────── P r o / E N G I N E E R ─────────────
Új hozzászólás Aktív témák
Állásajánlatok
Cég: Ozeki Kft.
Város: Debrecen
Cég: Promenade Publishing House Kft.
Város: Budapest