Új hozzászólás Aktív témák

• #1588 ASUSRT1200G+ újonc SpongyaBob #1587

  Új Válasz 2017-07-02 15:57:24 #1588

  Új hozzászólás

  Összes hozzászólása itt Válaszok az összes hozzászólására itt Válaszok erre a hozzászólásra

  Privát üzenet küldése

  

  ASUSRT1200G+

  újonc

  válasz SpongyaBob #1587 üzenetére

  after upgrade firmware remember must clear NVRAM !(procedure 30/30/30 is good)

  1) 30 Seconds Stage 1 – With power still enabled, push the WPS button/Reset and keep holding it in. You should keep the reset button depressed for 30 seconds.

  2) 30 Second Stage 2 – Then you should remove the power cable from the back of the router. Note that using a power button (if your router has one) is not sufficient. If you have the cable plugged in, the router can still hold some residual power. Do not let go of the button. It needs to be pressed in the whole time. Count a further 30 seconds…

  3) 30 Second Stage 3 – The final stage, we are almost there! Whilst still keeping the button depressed, power on the router again. Count to 30.

  We recommend using a digital timer for these steps. Consider using your phone stopwatch or something similar. You want to be as precise as possible with the timings. Whatever you do, make sure it is at least 30 seconds. 29 seconds doesn’t guarantee anything!

Új hozzászólás Aktív témák