Keresés

Új hozzászólás Aktív témák

  • GAI

    senior tag

    LOGOUT blog

    válasz ftc #21 üzenetére

    Ez csak urban legend, az NV30 (FX 5800) valójában egy feltupírozott és dx9 funkciókkal ellátott NV25 (GF4Ti) volt

    [ Szerkesztve ]

  • GAI

    senior tag

    LOGOUT blog

    válasz ftc #104 üzenetére

    Pont ezt mondom :) De a cikkből azt lehet kivenni, hogy megjelent, pedig nem...

  • Hunork

    veterán

    válasz ftc #104 üzenetére

    Hogyne lett volna megemlítve a TV- tuneres Voodoo...jobban kellett volna olvasni és figyelni, nem pedig a "mikor találok hibát" effektusra ügyelni... ;]
    Hivatkoztam forrásokra ezeket fel is soroltam, persze nem mindet, de én -többek között - ezt is találtam:

    ...shortly before 3dfx's death they made a prototype card which is a legend today: the Voodoo 5 6000. It had 4 VSA-100 graphic processors and 128MB video memory while all other cards had 32MB at the same time! We will talk about this monster in this article...

    továbbá:

    Voodoo 5 6000

    The Voodoo 5 6000 is the unreleased high-end product in the Voodoo5 line. It was to use 4x 166 MHz VSA-100 processors, each with its own 32 MB of 166 MHz SDRAM, resulting in the first 128 MB graphics card (consisting of sixteen 8 MB chips). Approximately 1000+ test cards were produced. Because the card used more power than the AGP specification allowed for, a special power supply called Voodoo Volts was to have been included with it. This would have been an external device that would connect to an AC outlet. Most of the prototype cards utilized a standard internal power supply drive power connector.

    With regards to performance, little was known until enthusiasts were able to get pre-release hardware and run tests on it. The results showed that the Voodoo 5 6000 outperformed the GeForce 2 Ultra and Radeon 7500, which were the fastest iterations of the GeForce 2 and Radeon R100 lines, respectively. (It was rumored that GeForce 2 Ultra was intended to prevent 3dfx taking the lead with their Voodoo 5 6000.) In some cases, the 6000 was shown to compete well with the next-generation GeForce 3.

    Unfortunately the production cost of the Voodoo5 6000 would have likely hampered its competitiveness from a profitability standpoint. Compared to the single-chip GeForce and Radeon cards, a Voodoo5 6000 is burdened with much redundancy and a complicated board. It was projected to have a $600 USD price tag, considerably higher than competing parts. Despite its high price point, the Voodoo5 6000 would not have offered next-generation DirectX 8.0 vertex and pixel shaders that would be found in the GeForce 3 (which was intended by Nvidia to replace the short-lived GeForce 2 Ultra as its flagship product) and Radeon 8500. The precarious financial situation of 3dfx was another factor contributing to the 6000's demise.

    There were five revisions of the Voodoo 5 6000: (the numbers after the model state the build week: 10 for week 10, 00 for year 2000).
    Intel Revision 1 (model 1000-1900)

    This was an early alpha of the card primarily used for photos and testing purposes. These cards generally had a short life expectancy, and were largely incompatible with various motherboards at the time. They also typically could not achieve speeds above 143 MHz without suffering from VSA-100 "death". This revision used an Intel PCI bridge chip (which can be seen towards the lower front of the card in the above photograph). It was equipped with 128 MB of 5.4ns SDRAM and used a proprietary external 3dfx power supply. Initial models had the chips mounted in the arrangement seen in the photograph, but this required a PCB with eight circuitry layers (most GeForce 2 cards were four-layer, while the Voodoo 5 5500 was six-layer) and would have been unreasonably expensive. All of the later revisions had the four chips mounted in a row.
    Revision 2 (model 2000-2900)

    This version dropped the Intel PCI bridge chip in favor of a HiNT bridge chip. These cards were able to be powered by either the internal system PSU or by a proprietary 3dfx external power supply, a feature seen in all subsequent prototype revisions. The clock speed varied from card to card, generally either 166 or 183 MHz. The VSA-100 chips used still did not have a long life expectancy, and may have had problems running anti-aliasing. This revision had 128 MB of 5.0ns SDRAM.
    Revision 3 (model 3000-3500)

    Cards from this revision varied in stability from dead to fully functional. A lot of problems had been fixed in this revision, but it still had VSA-100 thermal death problems above 183 MHz. These cards either had 166 or 183 MHz VSA-100 GPUs.
    Revision 4 (3600-3700)

    3dfx decided on 166 MHz due to issues with the 6000 running properly at 183 MHz due to a design flaw with the PCB. Most of the problems seen in earlier revisions were fixed, although there may have been glitches while in anti-aliasng mode on some cards. Most of the known cards are revision A from week 37, 2000.
    Revision 5 (model 3900)

    Little is known about this series except that this is the final revision. It was meant to be the retail unit, but shortly after the run of 10 were produced the 6000 project was scratched.

    Tehát: sosem írtam, hogy a kiskereskedelmi forgalomba széles körben bekerült, sőt, azt írtam, hogy nagyon kevés került boltokba, akár meg is említhettem volna, hogy most is gyűjtők kezeikben van, a fentiekből kiderül, hogy legfeljebb 1000 darab ilyen kártya került, ki, de elkészült, ezen kár filózni...az hogy nem hazánkban volt hozzáférhető...hát ez szerintem teljesen természetes... :)

    [ Szerkesztve ]

    "Semmi ok nincs rá,hogy a jó miért ne diadalmaskodhatna éppolyan gyakran,mint a rossz. A győzelem mindig szervezés kérdése. Ha vannak angyalok,remélem,úgy szervezkednek,mint a maffia." K. Vonnegut

  • Hunork

    veterán

    válasz ftc #113 üzenetére

    Most direkt nem figyelsz? :N Azt írtam, hogy ezekről NEM írtam, és nem is szándékoztam, így is iszonyú hosszú lett. Én EZT írtam:

    "A cég továbbá kitekintett a multimédia világába is, elkészítették a Voodoo 3 3500TV -t, a család leggyorsabb tagját (a Falcon Northwest változata 200 MHz-en üzemelt!), amely egy Samsung tunert is kapott. "

    "Semmi ok nincs rá,hogy a jó miért ne diadalmaskodhatna éppolyan gyakran,mint a rossz. A győzelem mindig szervezés kérdése. Ha vannak angyalok,remélem,úgy szervezkednek,mint a maffia." K. Vonnegut

  • Hunork

    veterán

    válasz ftc #118 üzenetére

    Újra:
    "A cég továbbá kitekintett a multimédia világába is, elkészítették a Voodoo 3 3500TV -t, a család leggyorsabb tagját (a Falcon Northwest változata 200 MHz-en üzemelt!), amely egy Samsung tunert is kapott. "
    :)

    "Semmi ok nincs rá,hogy a jó miért ne diadalmaskodhatna éppolyan gyakran,mint a rossz. A győzelem mindig szervezés kérdése. Ha vannak angyalok,remélem,úgy szervezkednek,mint a maffia." K. Vonnegut

  • Hunork

    veterán

    válasz ftc #125 üzenetére

    Na, akkor végre egyetértünk... :K
    Én tényleg arról beszéltem, ezt tudtam, és te meg nem, hanem arról, és én ezt eddig is tudtam... ;) Mondtam, hogy nem tudtam és nem is akartam mindenre kitérni, így is vagdostam a cikket, hogy ne legyen 10-12 oldal...mert már ez is sok egy átlagos cikkhez képest, nemhogy 12 oldal...de ha lesz időm, megemlítem utólag, majd este megpróbálom...

    GAI, daa-raa: pótolva és javítva!

    "Semmi ok nincs rá,hogy a jó miért ne diadalmaskodhatna éppolyan gyakran,mint a rossz. A győzelem mindig szervezés kérdése. Ha vannak angyalok,remélem,úgy szervezkednek,mint a maffia." K. Vonnegut

  • Hunork

    veterán

    válasz ftc #125 üzenetére

    Üdv!
    Na, a Voodoo TV 100 is bekerült, meg még az alaplapi próbálkozások is, sőt, egy kép is! :K :K

    [ Szerkesztve ]

    "Semmi ok nincs rá,hogy a jó miért ne diadalmaskodhatna éppolyan gyakran,mint a rossz. A győzelem mindig szervezés kérdése. Ha vannak angyalok,remélem,úgy szervezkednek,mint a maffia." K. Vonnegut

Új hozzászólás Aktív témák